PRODUCT DESCRIPTION &USE

Acrylic copolymer based emulsion for interior walls. Is a paint to have high-level effects of inhalation and washable. Can be made very different effects and shape available with different application tools. Can be used on Interior and exterior walls of buildings, of parking, warning signs ,plaster, gypsum plaster, concrete and wood surfaces

 

KEY BENEFITS

• Applied to the surface shows an excellent adhesion properties,
• Has a high level of inhalation property,
• Provide buildings breathing due to the ability of disposal out humidity from inside,
•  Durable against deletion that is clean easily,
• Can draw different figures on the walls of your room,
• Not smelling because of not contain solvent and thinned with water,
•  Not harmful to human and environmental health decorative.

 

AVAILABLE IN SIZES

In 1 kg, 3.5 kg , 10 kg , 20 kg  plastic buckets.

 

COLOUR & GLOSS RANGE

Yellow, red, blue, green, orange

 

FLASH POINT

Flash point of this product is 39°C . 

 

VOC CONTENT

Available upon request

 

COMPOSITION (NOMINAL)

Pigment: Lightfast pigment

Binder: Acrylic binder

Solvent: Water

 

SOLIDS – SPECIFIC GRAVITY

Volume Solids % 65 ± 2

Specific Gravity 1.50 ±0.05 kg/L   (@ 20 °C)

 

SURFACE PREPARATION

The application surfaces should be cleaned from the dirt, oil, dust and all loosen structured swollen layers, the faults on the surface should be removed.

 

APPLICATION

If the surface which will be applied need the repair, be done and all kinds of oil, dirt, dust  that will prevent adhesion  products must be cleaned. Then a layer of Southwind Fluorescent Primer should be applied. Then Southwind Fluorescent Funds Paints is applied two times the desired color. Painting process is completed by applying desired color, shape (arrangement) and type Southwind Fluorescent Topcoat on prepared the ground. Ready to use. Not thinning. 

Application Tools: Effect rolls, brush, sponge, chamois leather, plastic spatula, steel and plastic. 

 

SPREADING RATE

As depending on surface uniformity and application techniques 0.050 – 0.250 kg/m²

 

REDUCTION

Do not reduce this product

 

DRYING TIMES (SINGLE COAT, STANDARD THICKNESS)

At 20°C %65 HR), 

First Drying: 2 hours,

Full Drying :  24 hours.

 

 CLEANING UP

Clean up with soap and water. After cleaning up be sure to flush spray equipment with solvent to prevent rusting following manufacturer’s instructions. Dispose of can in accordance with local authority guidelines.

 

PRECAUTIONS / WARNINGS

Keep out of reach of children. Ensure good ventilation during application and drying. If the product comes in contact with the eyes rinse immediately with plenty of water. To remove splashes from skin, use soap and water or a recognized skin cleaner. Do not take internally. If medical advice is needed, have product container or label at hand. Dispose of contents to a waste disposal facility in accordance with local/national regulations. Safety data sheet available on request.

 

STORAGE

Non-receive direct sunlight on the floor, the storage room temperature should be up 0°C  and  under  +35°C, closed in volume, about 1 years in original unopened packaging. Keep from freezing.

 

FOLLOW US ON

Phone: +90 530 429 9233