Ceiling Plastic Paint
Ağustos 11, 2025
Silicon Based Interior Paint
Ağustos 11, 2025

Luxury Wall Plastic Paint

Top coat matt interior paint, based on PVA emulsion. Applied to the surfaces of the construction elements such as cement coat, gypsum coat, plasterboard, gas concrete, brick, etc…

PRODUCT DESCRIPTION & USE

Acrylic emulsion based, top coat interior paint.  Applied to the surfaces of the construction elements such as cement coat, gypsum coat, plasterboard, gas concrete, brick, etc…

KEY BENEFITS

  • Well adhesion to the application surface. 
  • Not crack or fall. 
  • Higher coating characteristics, 
  • Good quality and economic

AVAILABLE IN SIZES

 3.5 kg, 10 kg, 20 kg, 25 kg plastic buckets

COLOUR & GLOSS RANGE

Various colour options, matt

FLASH POINT

  Not Applicable since this product is non-flammable

VOC CONTENT

Lower than EU standards

COMPOSITION (Nominal)

Pigment: Lightfast pigment

Binder:    Acrylic binder

Solvent:   Water

SOLIDS – SPECIFIC GRAVITY

Volume Solids       70 ± 2%

Specific Gravity         1.7 ± 0.05 gr/ml

SURFACE PREPARATION

The application surfaces should be cleaned from the dirt, oil, dust and all loosen structured swollen layers, the faults on the surface should be removed. 

APPLICATION

Southwind Wall Plastic Paint is applied in two layers. 2 hours should be allowed between the layers. It is applied easily by fell roll or brush. It is recommended that it shall be applied between +5 °C and 30 °C.

SPREADING RATE

400-500 gr/m2 (or 250-310 ml/m2) for double layer application, depending on the surface condition.

REDUCTION

 25-30% water is added depending on the application surface

DRYING TIMES (SINGLE COAT, STANDARD THICKNESS)

Touch Dry 1 hour at 20 °C 

Recoat 4 hours

(Recoating time depends on temperature and humidity) 

CLEANING UP

Clean up with soap and water. After cleaning up be sure to flush spray equipment with solvent to prevent rusting following manufacturer’s instructions. Dispose the bucket in accordance with local authority guidelines.

PRECAUTIONS / WARNINGS

Keep out of reach of children. Ensure good ventilation during application and drying. If the product comes in contact with the eyes rinse immediately with plenty of water. To remove splashes from skin, use soap and water or a recognized skin cleaner. Do not take internally.

STORAGE

The product should be kept in a dry place. Lid should be closed     tight when not in use. Not to be exposed to direct sunlight. Stock life is 1 year in original container. Protect from freezing.

 

FOLLOW US ON

Phone: +90 530 429 9233